Z-Brace for Monoprice Maker Select Plus

I've collected all of the parts from both the parent project and the grandparent project.

The parent project didn't include the top braces nor the ball nuts, and two of the STLs were mangled (front right was miniaturized, back right didn't render properly).

These problems should be resolved now. Included in the pics is the actual hardware I used:

Qty 1: metal glides (feet), 1-1/16 inch 4pk
Qty 8: Socket Cap Screws M3 x 0.5 x 12mm (they come in packs of 3, so I needed to buy 3 packs)
Qty 4: Socket Cap Screws M5 x 0.8 x 12mm (they come in packs of 2, so I needed to buy 2 packs)

Qty 1: 36 inch 5/16-18 Threaded Rod (You'll need to cut this in half.
Qty 4: 5/16-18 Nylock Nuts
Qty 2: 5/16-18 Regular Hex Nut

For further details and advice, check the parent project and the grandparent project.

Important Note: While I show all of the parts on a single print bed, I'd advise against printing them all at once- if one piece chokes halfway through, it'll waste all of the filament.