September 12, 2017
Description
Full fender for the Onewheel and Onewheel+
There is a full version for reference, but it is best to print the center and two edges (with support). The one shown in the photo is split in the center, but there is no way to make it look good. It is better to place the seams where there is a natural corner. You can also try the center with 1 edge attached if you have 210mm in Z.
You will need a minimum 260mm square bed to print it. 10" is a bit too small, so this is best suited to 12" printers.
Because it is thin, a printed fender isn't very strong by itself. It works best if the inside backed with fiberglass.
License:
Creative Commons - Attribution
ianjohnson
