Inmoov Finger Pins

Many Thanks to “Mr Gael” Inmoov Designer

These are Finger Pins for joining the Fingers together- they have a flat bottom for easy printing… remember that the internal finger sleave is drilled out enough to allow it to swivel freely and the external are firm enough for the glue to bond –

I Strongly recommend doing a couple of test fingers before doing it to your good ones- this is Still R&D Stuff ,,,,so all Bets are off-

There 3mm in Diameter and are very strong due to being printed in the Horizontal position,
I used a 2.5mm dill bit for the exterior and 3mm drill bit for the interior – some reaming with the dill bit (feeding the part up and down in the drill press) might be needed to get perfect fit,,, but make sure you take the Corner Swell of the Pins first this can be done in the drill press with a file —basically theres a few ways to clean & fit them – they can be used as templates for making Pins out of - Aluminium / Steel rod / Copper tube ect,,, just thought a set of " Printable Pins" would be handy ,,,, had the file laying around for a while just uploaded them because a few people where talking the problem of buying a whole Roll of 3mm filament just to use 1 meter of it,,,, hope it helps you guys out

SketchUp file is Included

-=Mindless=-