Traxxas Rear Wing for Rustler/Bandit/Slash (All 1/10, 2WD) (V0.1)

I've made a new version of this, which is much improved: https://www.thingiverse.com/thing:5915878

---

Also check out my front wing - this will help even more with speed runs and will keep the car planted to the ground at high speeds. It works very well with this wing. https://www.thingiverse.com/thing:2563275

Now allows for a traxxas wheelie bar to be installed with some M3 screws. I used M3x40 screws to attach the wheelie bar to the rear.

The wing mounts mount on the rear where the stock bumper goes, and the wing slides snug onto the attachment rails on the top of the mounts. This allows the car to have lots of downforce and great control at high speeds. I've ran this with my Rustler VXL at 70+ mph and it works great.

Printing Recommendations:

WING: Print upright with the back of the wing on the buildplate, facing upwards. Print with supports on build plate.

MOUNTS: Print with supports on the build plate, with the mounts laying on the thin, flat side of themselves.

Print with PLA, ABS, or Nylon. Works best with Nylon, but it might be hard to print.