Filament Holder for IKEA Stuva

This filament spool holder is made for the IKEA Stuva corpus. (http://geni.us/IKEAstuva)*

I'm using this IKEA Stuva cubicle for my Anet A6/ A8 printer. It fits very good in the housing.

The spool holder will be clamped on the top plate of the cubicle an can be fixed by screws from the back.
In the standard version, both sides have the same size of the roll. Later I created an extra wide version for different spool sizes. The spools width from different suppliers differ, therefore it helps to make these compatible.

I used thoose ABEC-9 608 WHEEL BEARINGS for a silent rotation of the spool. (http://geni.us/BM2iYyb)*

For each roll, you need the spacer in the STL files.

For the assembling I used following parts:

4x M4 x 25 screws
4x M4 nuts
8x big M4 washers

My Recommendation: Press the ball valve in the roll directly after finishing the print. It's easier while it's warm. Before shrinkage!

*Affiliate marketing link. Thank you for your little support!