Summary

This is my first attempt at designing. I would appreciate any input/advice.

Inspired by 5imR's bed mounts, I decided to start learning openscad and design a variation that would allow for adjustments directly in line with the x, y, and z towers. The bed-supporting extrusions are 120mm to center, and the bed mounts are 30mm wide. 120 - 30/2 = 105mm from the end of the extrusion to the side of the mounts on either side. The design/code aren't all that pretty, but they definitely get the job done!

Hardware Used:

M410 screws & T nuts (x3)
M3 25 screws & nuts (x3)
1.2159.2 springs (x3)

Print Settings

Printer:

Anycubic Kossel

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>30</p></div></p>

Post-Printing

You may want to add the 3mm nut at the bottom. There's a spot for it if you need it. I find that the 3mm screw grips just fine without it.

How I Designed This

OpenSCAD

Anycubic Kossel Heated Bed Leveling Mounts

Anycubic Kossel Heated Bed Leveling Mounts

Related Models