EV Charger Type 2 Slightly Oversized FlashForge Finder printable

I took atlemo's charge plug holder and resized the base so that it will fit an 140*140mm FlashForge Finder base. Then I oversized it just a tad so it doesn't fit to tightly. After print i lay in a small strip of hot melt at the bottom. This gives it just enough friction to hold it in a snug fit.

The second version looks even better on the wall as it has its mounting screws hidden.
Use the center hole to add a fifth screw or nail to stop it from gliding upwards when inserting the charge plug.

Version 3 October 2018:
I noticed during the long hot summer that the PLA has expanded and then contracted so that the it gripped too tight now that autumn has come. Because of this I made a version which is larger and does not depend on a tight fit to hold the charger handle. Instead it has a little notch and a few ribs gripping it. This version is marked by a c.
I also fixed the screw-hole-distance bug in this version.

P.s
If you have a plug-in hybrid, live in a cool climate and have a electric engine pre-heater / car heater, I made a combo version which allows for both cables to be protected in the same holder. I posted it as a separate thing.