Imperial Dominion Crusader rearming platform assessories

Never run out of ammo in the field again with this Mechanicus unsanctioned rearming platform brought to you by Imperial engineering division XXI.

***Update: Updated platforms are completed and will be maintained as separate thing kits. Please see remix section "Imperial Walk Ways" and "Imperial Support Beams"

Note that this is no longer WIP - All the accessory parts in this thing have been test printed and should not change. Both structure things are still WIP. The only part that may need changing is the main forge unit. It prints fine but needs a spacer(hat) on top to meet up with the walkways

To print a complete Crusader rearming platform (as pictured) you will need to print:

Main Structure (see Remixs)
2x Imperial Walkway Curved A & B
Your choice of any 4 Imperial Support Beams
1x Connector piece - not yet published (will be in Imperial Walkways)

On Top
1x Rail 3 post A & B - Tested OK- part B with clips is new
1x Rail shield A & B - New version tested OK. part B with clips is new
1x rail with fan A & B- v2 changes made - both tested OK - part B with clips is new
1x fan pipe - Tested Ok (final - no changes expected)
1x energy loader pipe - Tested OK (final - no changes expected)
1x console - v2 changes made -

Forge
1x Main forge - test printing 3/7/18 Too small! Gap between forge and walk way is way too large. Will be fixed soon
1x secondary pipe - Test print failed. Prints fine but falls apart. Also needs re-scaling and does not fit nicely on main forge piece.
1x pipe top end - Test printed really well. Need to check it fits with other pipes - checked and it fits loosely. Needs rescaling and further adjustments.
1x Forge hat - so your forge dosn't get sunburned

Assembly Instructions:

Walk way A & B should just fit nicely together without glue (don't glue until after painting!)
Walk way B and supports should now slot together (testing still required).

To join the two completed walk way pieces (remember you need 2x of each A & B) I've included a connector piece that should slot into the holes.

Supports:
Glue part A & B together, glue C & D together. Slot into walk holes in walk way B

Rail with fan
Glue A & B together and then glue to pipe. Clip onto completed walk way

Other rails - glue A & matching B together and clip onto walk way

Main forge
Print all parts. All parts should slot into each other. Glue if needed

As this is WIP, any feed back is appreciated.

Also note that this is entirely made by hand using Tinkercad and is inspired by similar models. It is intended to add to, enhance and be compatible with said inspired models and is by no means a replacement.