These are "point" (or span) walls based off components from Devon Jones, in particular the bits from his ruined walls. Thanks so much Devon for providing all these bits!
I'm modeling after the Hirst Arts Gloomhaven approach. These are shorter than what Hirst is doing, more along the lines of a Wyloch/TrueTiles style of walls, but uneven.
As an aside, I'm doing a few uniform walls (like 2-a) with a consistent height, in case people prefer that sort of thing. A little more Wyloch-like than my first ones (although I still prefer the uneven ones, personally).
Unless your printer does some amazing bridging, you're going to need supports on these :).
Updates:
- 10/09/2019 - Added some stairs, look cool as a way to show where you're starting!
- 7/30/2018 - Added a 1-hex model with nothing overhanging, basically for use when you don't want to use another corner piece for aesthetic reasons.
- 7/28/2018 - Cleaned up 2-a model, had some internal structures that were leading to issues with my prints.
- 6/26/2018 - By request, a one-tile version with walls extending out both sides.
- 6/22/2018 - Rounded ends of 2-b, slightly lengthened 1-a. Only 2-a needs more work (AFAIK).
- 6/21/2018 - Rounded ends of three-tile version.
- 6/20/2018 - Rounded end of one-tile version, to better fit against corners.
- 6/20/2018 - First one-tile wall uploaded, also some blank tiles at the right spacing.
- 6/20/2018 - Second two-tile wall uploaded, first three-tile, more irregular like the flat walls.
- 6/19/2018 - Had provided wrong license temporarily.
- 6/19/2018 - For a few minutes, there was a totally broken example uploaded. Whoops.
rbross
