This helps the Snapmaker print in ABS by diverting airflow from the fan up and away from your print. ABS likes it hot and airflow over the print can cause the print to cool too fast resulting in warping.
This remix takes the original work of X_Pilot and the remix by adelille, and adds in an interior duct wall and additional support pieces. The result is less defects due to bridging at the cost of using more filament. No additional support is necessary to print this.
I printed it using the default fast settings in Snapmaker3D in exactly 2 hours.
Check out the section below to see how I did this in OpenSCAD
If you like this model please give me a like on the Snapmaker facebook page. For every like I get over 100 during the month of October I'll get a $1 coupon to help me purchase more filament for more models!
https://www.facebook.com/groups/snapmaker/?multi_permalinks=575897572828560
greyphilosophy
