The purpose of this design is twofold. First, fix known issues of CC-00 by using whoop form factor to provide better protection. Second, investigate the feasibility of using PETG as the material for printing the frame.

Features

1. Can use 16x16m Flight Controller stack or typical 36x36mm whoop FC.
2. 0-45 degree adjustable camera angle.
3. Battery mounting solution is very flexible. Can add more 1S battery by using more battery holder. (Mind the voltage limit of FC and ESC)
4. Only use M2 screws and nuts
5. Easy to print (Only the frame needs a little support)

Specifications

• Motor: RacerStar Racing Edition 1103 BR1103 10000KV Brushless Motor
• Prop: RacerStar 1535 38mm 1.5mm-hole 4-blade propeller
• ESC&FC: HappyModel Super_S F4 2S 16x16mm Flight Controller + BLHeli_S 6A ESC
• Camera: Caddx EOS2
• VTX: Runcam TX200
• Receiver: FS-RX2A
• Battery: Team Black Sheep Graphene 260mah 1S HV

**Note: ** Frank Zambrana succefully tested the frame with crazybee F3 (link)

Known issues

1. No direct access to USB port
2. Direction of VTX antenna is not ideal
3. The PETG frame is not tough enough for hard crash
4. Doesn't support smaller motors (e.g. 0603, 0705, 0804) at the moment (Will publish new version later)

Update Log

• 2018-11-11 23:47 NZDT

1. Uploaded cc01_battery_holder_v2. (Added a ring for battery strap to get through, so the holder is less likely to be missing)
2. Uploaded cc01_battery_base_v2. (Reduced its height)
3. Updated the picture of battery mounting solution.

• 2018-11-15 14:50 NZDT

1. Uploaded cc01_frame_v2. (Enhanced the strength and improved the air flow)
2. Updated the image showing total weight.
3. Updated the image showing battery pad.