Daedric Armor split for smaller printers

This is the same size models but just split for smaller printers (I made mine for my Anet A8, which is about 220mmx220mmx240mm). All the models were split using Blender and I am including those files as well. As soon as I split and print the rest of the files I will add them. Thanks Jace1969 for the wonderful models!

Update 1: Finally perfected the fingers of the armor, split the original into two pieces for each finger and got them to print smoothly, for my fingers at least I had scalings of thumb at 115%, pointer/middle at 110%, ring at 100%, and pinky at 85%

Update 2: I have uploaded the files for the split shoulders and left boot. The shoulder pads are the same on each side so all you need to so is flip the left one for the right, but you cant do that for the full shoulder as one is bigger than the other. The same is true for the boot, I have only uploaded the left boot because all you need to do is flip it to make it the same as the right boot. If needed, please comment that the files for the right side are needed and I will make the files. Hopefully the chestpiece and the thigh pieces will be added soon once I finish printing them (to make sure all the models print correctly).

Update 3: I have uploaded the completed split thigh pieces, as well as the complete full armor set split in a single file. Soon after this I will add the chestpieces after i size them down (I had adjusted the files to fit me). so they fit 1:1 with the rest of the armor, then all of it will finally be uploaded! -(they are all there now :) )

If you have been wanting to print this set but the files were not working, I have reposted them so hopefully you can get to printing it soon!