FR# Print Files

NOT FOR COMMERCIAL USE

Prints for the FRH, FR7, FR8, FR10, and Slammed FRs.

DJI HD Notes:
Most builds will require a longer camera cable, such as the Caddx 20cm cable.

Arm Guard:

• Frame Specific

Immortal T Horns:

• Universal, expected to work with Session and Hero 7 mounts

HD Camera Holders:

• Session ND: designates Session 5 with TBS or Pyro ND filter
• Hero 7: designates Hero 7
• Hero 8: designates Hero 8
• Hero 9: designates Hero 9
• Logo: designates logo on holder

FPV Camera Uprights:

• Session: designates Session 5 specific Uprights
• Universal: designates Session 5 and Hero 7 Specific Uprights
• Full Size: designates Full Size camera or Mini camera with adapter
• Micro: designates Micro (19mm wide) camera. The original Session Micro upright should be compatible with both Session 5 and Hero 7 camera holders, for most camera angles. A Univeral Micro Upright has been added, which raises the camera by 3mm, allowing for lower FPV camera angles.
• Slug: designates addition of stiffening slug
• Hero 8 and Hero 9 have dedicated uprights
• DJI has dedicated uprights and POD option.

Platypuss Tails:
Assembly will not accept the TBS bulkhead style coax connector.
MMCX coax will need to be a 90 deg MMCX connector, 10cm length seems to work well.
Works with 18x18 Micro Ublox GPS

• Diversity: designates Crossfire Diversity shelf
• Mach3: designates Mach3 shelf
• Unify HV UFL: designates Unify HV (800 mW ufl connector) shelf
• Unify HV MMCX: designates Unify HV SE (1000 mW mmcx connector) shelf
• Triple SMA: accepts triple SMA coax connectors
• Double SMA: accepts double SMA coax connectors
• StraightSMA: SMA hole comes out straight from the tail
• AngledSMA: SMA hole comes out angled from the tail
• RXHoles: accepts standard 3mm OD antenna tubes
• 180GPS: designates BN-180 GPS
• MatekGPS: designates Matek SAM-M8Q GPS

Prints for the FR# SLAMMED (does not fit FR10)
Slammed version uses 18mm front standoffs and 10mm rear standoffs.

Designed for the FR7 v4, to provide a flat surface for bottom mount batteries and a place to add small components, like a rx module. May work with the FR7 5.#.

Trunk Info:
v4.#
TPU Files
The following require, M3x6mm, 5mm OD standoffs.

• Trunk Empty_Standoffs*
• Trunk Hex Fillers_Standoffs (hex shapes for added stiffness)

Rigid Material Files
No standoffs required

• Trunk_Rigid Material_without Standoffs

v5.#

• FR7 requires M3x6mm, 5mm OD standoffs
• FR7Heavy requires M3x12mm, 5mm OD standoffs
• Both require qty2, 3mm threaded studs in order to interface with top plate standoffs on one side and trunk standoffs on the opposite side. Can substitute a std 3mm fastener with the head cut off.
• Carbon plate is 2mm thick, ref attached plate files
• Use slot print aid, PLA, in order to create a clean slot without the need for hard to remove slicer supports.