[The SQ-13 is a cute little camera.](https://www.amazon.com/gp/product/B07L4HT568/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1) that I whipped up some mounts for in Fusion 360.
If you want to tweak the design here are links to the 360 files.
- [BT-50](https://a360.co/2E6Etjt)
- [BT-60](https://a360.co/2DWvtNr)
- [54mm](https://a360.co/2VfUejn)
Notes:
- All the nose cone caps will need to be fastened either with small screws or CA glue.
- Each nose cap has a hole at the tip for attaching a parachute line.
- There is a notch in the shoulder so the parachute line doesn't bind with the airframe.
- The camera does snap into place but you should consider using a small screw to lock the camera onto the nosecone.
- There is a lot of room inside these for possible avionics.
Works-Of-Claye
