Nirvana NV-14 custom cover

This is custom cover for Nirvana-NV14.
I made this because stock one sucks.

My version is easier to put on or to take off. It is strong and nice at least for me.

Check the youtube video:
https://www.youtube.com/watch?v=7prPJmUKDbg

Can be printed in PLAX, PLA+ etc..
Infill ~30% or more.
Layer 0.2mm
Wall 1.2mm
Use Roof/floor for suppors if you use cura.
Lay flat on the bed, use supports. I did not optimised model for less supports. For me the model quality was more important than print time and 50gr of filament :)

There are two versions. Check the STL's all diferences are visual. Lite version is more open, for me visually looks better.

Spent a lot of time and filament to make it perfect.. so coffee and stuff you know woud be much appriciated.

Note- this cover snaps on only if strap is not attached. I made so because i deatach strap each time I go back from flying. For strap I made this:
https://www.thingiverse.com/thing:3147830

Also my smoked gimbals:
https://www.thingiverse.com/thing:3196024

And wall mount for the Nirvana:
https://www.thingiverse.com/thing:3487239

Update:
Now i am making another version for those who will have strap attached permanently. No ETA but soon :)

Update2 (v2):
New versions (v2) - small update for better fit.
Added versio for those who have strap attached permanently (NOT TESTED FULLY). So any confirmation is welcome.