Raspberry Pi 4 case (with optional 30mm and 40mm fan mount)

Raspberry Pi 4 case with optional 30x30mm or 40x40mm fan mount. No screws needed to assemble.

Print with PETG or ABS because parts of the circuit can reach as high as 80°C. I suggest adding support manually for easier removal, see preview.

Modified at 2019-06-30 18:00:

• Spike position

Version 1.1 (2019-07-03):

• Better airflow: larger top vent holes, additional vent out hole above the plugs
• Reinforced pillars between the USB/Ethernet ports
• LED holes
• Middle support in latch holes
• Claws on latches got bigger so they hold the parts better together
• Added version with no fan holes (passive cooling)

Version 1.2 (2019-07-03 11:40):

• 3mm higher design to cater for higher heat sink
• One more vent hole
• Strengthened latches on the sides

Version 1.3 (2019-07-04 11:10):

• Better ventilation below the board: added vent holes at 3 edges
• Added grille below the chips

Version 1.4 (2019-07-09 10:50):

• Slightly redesigned connector side (power + HDMI + headphone jack)
• Added trailer elements below USB + Ethernet ports

Version 1.5 (2019-07-13 13:25):

• Adjusted connector positions to match the documentation:
  https://www.raspberrypi.org/documentation/hardware/raspberrypi/mechanical/README.md

Version 1.6 (2019-08-22 18:12):

• Added 30x30mm fan mount version

Note, if the case won't fit the board, check out the audio jack hole, which has a thin bridge above and tends to hang below. You can ease the top part with a carver blade. See the photo with the red arrow!