February 6, 2020
Description
The smaller magnets on the original model weren't quite strong enough for thicker flight suit material. This was remixed to utilized 12x3mm magnets which are readily available on Amazon, Ebay, etc. I also created a magnet holder for inside the flight suit for quick on/off capabilities. Like the original, this works with a 1/2" OD hose. I did my best to orient the magnets in a position that would not interfere with any thread should you decide to drill it out and make it appear as if the connector is sewn on.
Follow your preferred method of filling/sanding and prepping for paint. For GB-1 paint the connector grey, for GB-2 paint it a greyish tan.
License:
Creative Commons - Attribution - Non-Commercial
6
arkraider
