Raspberry Pi 3 Case with Homematic RPI-RF-MOD

This is an easy to print case for the Raspberry Pi 3B+ and the Homematic RPI-RF-MOD
It's for the Pi 3(B+) only and won't work with the Pi 4 - for the Raspberry Pi 4 based case click here.
You need 3x M2.5x6mm screws

After the print, remove the integrated supports in the HDMI and Micro-USB Ports with a sharp knife.
Then insert the RPi and fix it with 2 screws to the bottom.
Install the RPI-RF-MOD and close the case with the top. insert the last M2.5x6mm screw into the square hole and secure it.
One hole at the top of the case shows the Status LED (bigger one) and the other is to press the reset button with a needle or similar small and thin piece.
I highly recommend to use small rubber bumpers (like 3M bumpon) with a diameter from 7-9mm on the bottom part to keep some distance to the wall/surface and not covering the venting holes.

I designed a clickable insert for this square hole so you can make your own "stickers" on it. (or use the raspberry in the example). For this please use the Nupsi.step as a start.

Parts to print:

• 1x Bottom.stl
  OR

• 1x Bottom_mounting-holes.stl
  OR

• 1x Bottom_ext_ant.stl

• 1x Top.stl
  OR

• 1x Top_vent.stl

optional:

• Logo_example.stl
  or any of your own designs using the Nupsi.step as mounting base

[UPDATE 09/MAR/2020]:

• Added bottom part for wall mounting using 2x 3.5-4mm screws

[UPDATE 11/MAR/2020]:

• Added an optional top with venting holes

[UPDATE 14/MAR/2020]:

• slight adjustments for easier RPi installation

[UPDATE 31/AUG/2021]:

• added Bottom with bore for an external antenna