Volvo 480 - belt arm repair

Belt arm repair part for the Volvo 480. The end the arm has a small plastic rod that quite easlily breaks. I have made two new rod were the idea is to drill out the broken one glue in a new printed one in it's place.
There are two versions:
1: seatbelt_extender_repair_half_v1.stl
This is the one I used when only the tip of the rod was broken. I cut thin part of the rod and then drillen a hole (5mm) in the base of the rod and glued the new tip in place.
2: seatbelt_extender_repair_full_v1.stl
This is the one to use if the whole plastic rod i broken. Then you need to drill a bigger hole (7mm) inte the base of the belt arm and glue the new rod into.

This is for the earlier 480 models, I plan to make one for the later also.