Behringer XENYX 302USB Stand

For the longest time, I've had my input mixer leaning up against some small boxes. Then I printed the stand here https://www.thingiverse.com/thing:2038119 However I didn't have a good matching set of hardware to fit snuggly against the frame. So I decided to model a version which fits into the side clips!

It provides enough stability without needing the screws on the back, and doesn't require any additional hardware. Just a standard Philips head screwdriver is needed to remove the screws.

The fit is decently tight, since I modelled it with 0.2mm clearance. Definitely make sure your print bed is properly levelled and doesn't produce too much of an elephants foot.

I've been learning how to use Fusion360 and have made a lot of other models, but this is the first one I've decided to share since I know a lot of people could benefit from this.

Let me know what you think!

You can support my work here: https://ko-fi.com/umar167