Rolling log mouse trap for IKEA SAMLA bin, with printable ramps

Based this off the "rolling log" mouse trap, needed something for my RV, we're having it sealed up from mice but still have the odd little bugger that makes it in, figured this is more reliable than a 1 use mouse trap since we only make it out there every week or 2 to check on it.

Anyway it's made to clip on to the edge of the SAMLA bin, label is in the photos, it's just a bin i had laying around, and it's very cheap, i liked the low profile when compared to bucket setups so it's a little less effort for the mouse to get in there, and fits nicer in the corner of a room. It uses typical 608 skateboard bearings, and just a scrap of tube i had laying around, i didn't really know what it was, but i googled the numbers in the photo and it looks like it's some kind of PVC, the OD of the adapter for it is 15.5mm and it fits quite well inside, so you may need to make some other adapter for whatever you use for the tube.

EDIT: try1 wasn't very successful, not sure if the bin was too short or the bearings didnt spin easy enough or a little of both, all the bait was gone, there was a lot of mouse crap in the water, but only 1 dead mouse. Will have to try some other ideas.