Hemera fan duct with integrated ABL mount for Artillery Genius/Sidewinder

Update 2 - 12/06/2020 - Added v3 which supersedes v2. Only minor aesthetic changes and additional clearance for wiring the probe.

Update 1 - 12/06/2020 - Added v2 with central duct outlet included to improve cooling while maintaining a view of the nozzle.

This is a remix of a part cooling fan (5015) duct for the Hemera with an integrated mount to use the stock z endstop sensor as an ABL probe on the Artillery Genius (or Sidewinder X1).

The main purpose of the remix for me was to incorporate the sensor mount allowing auto bed leveling thanks to the guides by Ciprian at 3dprintbeginner.com:

https://3dprintbeginner.com/artillery-genius-auto-bed-leveling-stock-sensor/ https://3dprintbeginner.com/sidewinder-x1-auto-bed-leveling-stock-sensor/

The duct has also been revised to allow a better view of the nozzle by removing the central outlet. The side outlets have slightly increased to help compensate. Overall cooling output is reduced (but still fine) so I may look at reintegrating the central output.

Mounting the sensor flush with the bottom of the bracket and fan duct puts it in approximately the correct position relative to the nozzle. There is also plenty of adjustment available for the probe up or down while the mount maintains correct perpendicular alignment to the bed.

M3 hardware including washers required (12mm on the sensor).

Nozzle to probe offsets are approximately:
X 40
Y -47

It can be printed without supports in the installed orientation.