NoClunk Gravity spoolholder for MMU2S

A no clunk adaption of the wonderful "Gravity spoolholder for MMU2S" by Michal Fanta (https://www.prusaprinters.org/prints/10370-gravity-spoolholder-for-mmu2s)

Video: https://youtu.be/Li5INzZ04JA

Many of the gravity rewinding spool holder allow the spool to continue spin at the top, by jumping over the gears and making a clunking noise. This adaption allow the spool to continue to spin by only holding the spool to the pin with a small amount of friction.

Assembly Instructions:

1. Add Stopper to the top right frame. This will stop the Pin turning when it reach the top.
2. Glue Gear to one end of the Pin (then wait for glue to dry). Insert spool. Add the other Gear and tighten it, so there is only a little friction between the spool and the Gear. Apply LockingNut, so the nut won't further tighten or loosen.
   As I don't want the spool to jam. I tend to place the Pin onto the frame orientated such that the pull of the filament will try to loosen the nut.
3. If you tend to over tighten the nut. You can add the ShelfClip to stop the holder lifting.

You can check out my other prints at https://www.thingiverse.com/highrise_workshop/designs. And don't forget to click the "Like" button.