October 11, 2020
Description
Wedge to raise the ender 5 power supply cover.
These shims were made to replace the noisy fan of the power supply by a 60x60x25 noctua. The noctua being higher than the old fan, it was necessary to slightly raise the power supply cover.
You will need to use M3 screws. Personally I used four: M3:4 and four: M3:8.
There is however a small defect to that, the cover of ender does not close perfectly, but this is invisible, because it is located below the printer.
WARNING: Touching the power supply is very dangerous and not recommended, you do this at your own risk. I do not guarantee that these shims are not dangerous.
License:
Creative Commons - Attribution
Eriwyr
