December 25, 2020
Description
Measured and mockup of the New FliteTest Firewall. This is the one used in the new mighty Mini Zero they recently released. I got to upload a edited one for the new Mighty mini Corsair, as the diameter is larger. but otherwise it's very close.
you may need to tap the motor holes with a drill to fit the motor to it, but I adjusted the model from the V1 that I made for myself so it should work if your printer is accurate.
The motor mounting plate mounts to the rear backplate using the spare longer servo screws included with all their A and F packs (the 5g servo's) any self tapping screw about or over 2mm should work however.
As always, please share your makes and provide feedback!
And as for how I have a scratch built model before the plans were released? I traced the kit onto some spare foam-board so I could build one from scratch! (these models CAN use the old style mini motor pod however!)
This is a close measurement of FliteTest's design and all rights go to them, I have this set as non-commercial as such. Enjoy for your scratch building delight!
License:
Creative Commons - Attribution - Non-Commercial
Intashu
