Modified Link Plate for Triple Noctua Fan

this is a small modification to the original Link Plate.

I had the issue that the edges of the side mounts were too thin/brittle and would break at last part of the print.
To solve this I modified every fan mount edge of the print to be slightly thicker than originally.

While modifying I also found some leftover elements (too small to be printed, but enough to move the design) that would lift the print a few millimetres off the bed, causing it to print supports underneath the front face of the mount.

in total this modification has the following:

• Slightly thicker edges of each fan mount (by just a few millimetres)
• Each flat side is cleaned up to make sure there are No leftover elements that could disrupt the end result.
• sharp edges on the inside of the side mounts on the original print are also removed, making it look slightly smoother.