Summary

I wanted to use a GPIO-connected 480x320 touch display that I purchased a few years ago for a project but the case it came with doesn't fit a Pi 4 (and it didn't have any vents), so I whipped up my own using the mechanical drawing of the board from raspberrypi.org. It's not pretty but it seems to work.

The display connects to the GPIO right through the lid with the rectangular hole.

The lid snaps into place and is easy to remove.

Print Settings

Printer Brand:

Creality

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>CR-10S</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>200</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20</p></div></p>                                                    <strong>Filament:</strong> Unknown - very cheap PLA                Black                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Nozzle size: 0.6mm<br>Initial Layer Height: 0.2mm<br>Layer Height: 0.2mm<br>Wall Thickness: 2mm<br>Top/Bottom Thickness: 3mm<br>Ironing: NO<br>Skin Overlap Percentage: 10%<br>Infill: 20% density, cubic, 30% overlap percentage<br>Bed Temp: 60C (initial and throughout print)<br>Nozzle Temp: 225C (initial and throughout print)<br>Initial Layer Flow: 125%<br>Flow: 100%<br>Retraction: Enabled, 6.5mm<br>Print Speed: 40mm (all aspects)<br>Travel Speed: 80mm<br>Combing: Not in skin<br>Initial Fan Speed: 0%<br>Fan Speed: 100% at layer 2<br>Support: Everywhere, 85 degree overhang angle, line pattern, 5% density<br>Build Plate Adhesion: Brim, 5mm, only on outside</p><p>Print with flat side down. Took about 3:45 to print.</p></div>

Raspberry Pi 4 Case for 480x320 GPIO Display

Raspberry Pi 4 Case for 480x320 GPIO Display

Related Models