Camera Zero

This is an actively-cooled compact camera housing for a Raspberry Pi Zero WH, PiMoRoNi Trackball, an Arducam High Quality Camera kit, and an Adafruit 16-pixel RGBW Neopixel ring light.

The software for this build can be found on Github.

Getting Started

You will need the following non-included parts:

• (1) - Raspberry Pi 4B
• (1) - Micro SD card (Sandisk preferred)
• (1) - Arducam High Quality Camera with 6mm CS Lens
• (1) - PiMoRoNi Trackball Breakout
• (1) - Adafruit 16 x 5050 RGBW Natural White NeoPixel Ring
• (1) - Set of 10cm Female to Female Jumper Wires
• (1) - Noctua 40mm x 10mm 5-volt Fans
• (1) - 40mm Fan Grill/Guard
• (1) - Set of M3, M4, M5 Cap Head Screws
• (1) - Set of assorted M2.5 Cap Head Screws

You may need the following additional tools:

• Metric tap set
• Needle nose pliers
• Xacto Knife (for cleaning up small imperfections in prints)