April 20, 2021
Description
After getting a Peanut I redesigned the mount to support both cameras. It leaves the back exposed to support the charging-while-flying backpack. I recommend using a thin strip of gorilla tape around the whole setup when flying for added safety in case your plane experiences a Rapid Unscheduled Disassembly.
Use that rudder channel on your flying-wing for something!
Get the TGY-R5180MG 180º servo and extend the PWM output to 700-2300 (on either your FC or transmitter). This gives you 270º of rotation!
The Caddx Nebula Pro version needs no support to print. The DJI Air Unit version needs support only on the front overhang. I print mine in the super strong HTPLA+ from Fusion Filaments.
There's two versions of each mount. One ID3.75 mm for most printers and an ID3.5 version for super tight tolerance printers. Your first layer will probably interfere with it fitting on the servo horn, I use an exacto knife to chamfer the opening a little after printing. Bolt it on and you're ready to rock!
Please post 'em! Really! Take a quick cameraphone photo of your print in all its glory and show it off! Plus it really helps get this design out there to the world.
Designing stuff is fun but interacting with cool people and hearing about their adventures is better. I can generate any variation / engraving easily, message me on discord/telegram and/or leave a comment and let's make your perfect version. I only ask that you post a make!
If you'd like the CAD or STEP file too, no problem. I've already helped a bunch of great folks! Send me a ping
License:
Creative Commons - Attribution - Non-Commercial
t4obrien
