Summary

Filament guide for the Sunlu FilaDryer S1 that allows the filament to curve gently instead of introducing sharp bends. It's angled as much as possible (21°) while still fitting into the stock outlet hole on the dryer, and uses a push fitting to hold the PTFE tube in place.

Print Settings

Supports:

Yes

                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Print standing upright with supports. The part that goes through the hole on the dryer is very thin, so it tends to flex and break if the layer lines run across it.</p></div>

Post-Printing

Parts List

            <div><ul><li><strong>4mm PTFE tube</strong> - I used a Capricorn tube, and it was a tight fit. You might have trouble getting a different brand of tube in.</li><li><strong>PC4-M10 push fitting</strong> - This is a passthrough fitting that allows the entire tube to go through, not just the filament. It's probably the same as the fitting on your hot end, not your extruder.</li></ul></div>                <p class="detail-title"><strong>Assembly</strong></p>            <div><p>Assembly should be straightforward once you have the correct parts. The screw threads are a tight fit; you will need a wrench. Also make sure you pass the PTFE tube past the edge of the print a bit to encourage a gentle curve into the tube.</p></div>

Angled PTFE Tube Guide for Sunlu FilaDryer S1

Angled PTFE Tube Guide for Sunlu FilaDryer S1

Related Models