Voron 2.4 350 spool holder, Pi camera mount, deck panel clip

Internal spool holder for Voron 2.4 350 build.
This keeps the filaments warm and dry while printing.
Especially filaments such as Nylon, PETG, TPU, etc. are very susceptible to moisture.
Of course, the spool reduces the height of printing, but I personally very rarely have to print more than 18-20 cm in height.

For some filaments it may be necessary to reduce the flow rate by 2-3% because the path of the filament is shorter and with less resistance.

One of the parts is original from Voron Switchwire spool holder.
One M3x12 bolt with hammer nut and PTFE 4 / 3mm pipe for the guide is needed.

ADDED: Pi Camera mount
For me best place is on the back side, see on pictures.
M3x10mm 2pc for top
4pc for camera same as voron 2.4 endswitches screws.

You need to have gap between deck panel and aluminium profile for the flat cable.
If you dont have its very easy to make it with knife.

ADDED: Deck panel clip
I have Formboot kit and deck panel is bending a lot from temperatures.
Front and back side can be fix direct to the 2020 bed profile with T-nus, but left and right side need clips.
They are two types with and without hole for M3 screws.