Lowrider2 Y Plate Template - 25.4mm

This is for the 25.4mm kit.

Based off of frederikkemner's design, but made using the latest Y_plate dxf.

If you don't have access to a CNC, you can print this part on a 200mm x 200mm bed and use it as a template for manual routing.

To print full 200mm with Cura, set:

• adhesion type = brim
• brim line count = 0
• travel avoid distance = 0
• horizontal expansion = 0
• support horizontal expansion = 0 (if support is enabled)
• draft shield disabled
• ooze shield disabled
• infill wipe distance = 0

Print it out with multiple perimeters and at least 25% infill for maximum rigidity.

Attach it to your MDF with a couple of clamps or double sided tape and drill the holes using a drill press. Flip the template and use bolts in the overlapping holes (e.g. the four around the rectangular middle opening) as registration markers. Drill the remaining holes.

Use a flush cutter (up to 6mm) to manually cut out one side of the part. Then flip the template again and cut out the other side.

Use a flush cutter with a bearing so the rotating shaft of your cutter does not touch the printed part (it would melt)