## Ender 3 V2 Quiet Fan Shroud/Cover
Much quieter, good airflow, easy to remove.
Instructions:
- Buy four
Orion OD4010-24LB 24V fans.
- Use one to replace the fan in your electronics housing
- Print this file. Orient it like the photo attached and use Cura's tree supports *touching buildplate only*.
- Remove the original fan shroud, and clip the fan wires.
- Solder one fan to the wires that went to the heatsink fan.
- Solder two fans (in parallel) to the wires that went to the old blower fan
- Make sure to use heatshrink or electrical tape over each wire splice.
- Slide the heatsink fan through the new shroud from the inside, and then attach with 4 M4 screws
- Add the other two fans and attach with M4 screws
- Line up the groove on the back of the shroud with the plate, and then insert a M3 screw through the mount hole. An M3 bolt will catch the screw from the front
Enjoy a much quieter hotend!
Now you'll want a quieter PSU fan :)
kth0
