Glock Mag sleeve g17 Mag in G19 P80

Summary:

Glock 17 style magazine in a Glock 19 style frame Shown on P80 frame. Yes its been done before and done over and over. I am learning...

What I have done was create a adapter for g17 style mag into a g19 style pistol but include a rather large finger groove.

I made this in TPU so it will fit tight around the magazine floor plate. To me (larger hands here) it feels good to have the extra grip length and positive feel of the finger groove. Try it and see if you like. Refine it, smooth it, make it nicer and let me know.

Don't like the gap at the rear? https://www.thingiverse.com/thing:5231655 use that style plug also TPU.

Printer:
Any Cubic Predator

Filament:
Sunlu TPU 1.75

Settings:
Temp 218c, .2mm, first layer 20mms, print 30mms, bed temp 60c

Rafts:
No

Supports:
No

Notes:
I am working on a grip plug to fill in the gap this created on the rear by loosing the tip to print this upside down. The tips on most of these mag fillers never fit right anyhow.

DISCLAIMER:
Use at your own risk, not guarantees expressed or implied.