Vocore 5" Dash Enclosure for Fanatec csl-dd & dd-gtpro wheel bases
Hi everybody!
This is my first project shared to Thingiverse. Feedback is welcome - I hope this comes in handy for someone who was looking for what I was. The original design was great - main tweaks were for mounting & narrowing the complete build down. The case design itself was already great and I take no credit for it. :)
Righto boys & girls here's what I did:
Printed the 4 stl files on my FLSUN Super Racer - 0.2mm layers, 100% infill, 100mm/sec. No supports needed.
Pictured print is using eSun PLA+ at 210/60
Parts:
* M3 x 16mm Bolt (x4)
* M6 x 16mm Bolt (x2)
* 10mm x 3mm Magnet (x4)
* Vocore screen 5" (x1)
* Hot glue gun
* cable tie (x1)
* 2m braided Micro USB cable
What I have remixed:Base Plate:
* Changed screw holes to 3mm
* Added in magnet mounts to suit 10mm x 3mm magnets
* Added notch to bottom right for USB cable
* Dropped the overall height down from (I think) 17mm to 10mm - quicker to print, neater package, and plenty of room for the USB cable I used.
Centre Plate:
Unchanged
Top Plate:
Unchanged
CSL-DD/DD-GTPro Bracket:
Designed simple adjustable magnet bracket to suit CSL DD / DD-GT Pro wheel base. I believe the spacing also suits other Fanatec wheel bases but I am unable to test.
~~I should have made the arms for the screw holes wider to match the cross bar - it would have been neater & stronger. I may update this but this won't affect usage in any way.~~
Used a small dab of glue to hold magnets in bracket.
UPDATE 26/07/22: Added V2 of the bracket.
* Removed the holes and went for a slot layout instead - finer adjustment & goes lower overall than before.
* Bracket significantly stronger - widened to match T-bar. Looks better too
* Added a pretty little border for a filament change print.
See pics of new bracket above. Don't use the original bracket at all, no reason to.
UPDATE 29/06/23: Added V3 of the bracket.
* Extended the height to be able to miss the shaft clamp and lower the height of the display further. It's Bullitt branded now.
UPDATE 29/06/23: Added a Bullitt branded shaft dust cover.
Other Notes:
Had issue with the base warping with pictured print, however warping was minimal and actually suited the design of the case so I am moving it from the 'mistake' column to the 'undocumented feature' column.
Used a small cable tie to hold USB cable in place - any pressure on cable will be stopped by USB plug & cable tie and will not damage ribbon connectors on the screen
Simhub Setup:
1) Install Windows Driver:
Link to current USB drivers for Windows 10/11:
https://simhubdash.com/Drivers/VOCOREScreenSetup.exe
(I have tested in Windows 11 and it works fine)
2) In Simhub under Dash Studio / VOCORE and 'enable display'
3) adjust settings to taste and you're done! That's really it!
Special thanks in general go to Michael Laws @ TeachingTech - if it wasn't for your videos so many of us would never have gotten anywhere.
https://www.youtube.com/c/TeachingTech
Choofthur
