Cycplus M2 Protector

This low-cost bike computer with gps and ant+ equipment - I thought it needs a protection.
Its display needs a higher edge - if you lay it facedown on the table - scratches will happen.
My printed part fitted strong, so I make the inner diameter 0,2mm wider. Print it with PLA, you can snap it in. if its to wide some layer tape would help.
If you print with flexible TPU I think it would help to reduce in cura some percents.

Don't know if there is someone out in the world to need this too - enjoy!
perhaps you visit my youtube channel to find diy videos and perhaps you'll improve your german, like I do with english videos. Like, subscribe and adopt me :)

https://www.youtube.com/c/basteley

Thanks - bye-bye from good old Germany
Wolfgang Ley - Basteley