Raspberry Pi HQ (High Quality) Camera Cover

This is a remix of the 'Raspberry Pi High Quality (HQ) Camera CASE' by mitchell_cj

Requires 4x 8mm M2.5 countersunk screws for assembly. The 'back' part has M2.5 threaded holes that are tapped post-printing.

The 'front' part is 3.05mm thinner than the original, allowing it to be assembled more easily without the need to remove the adapter ring.

The frame around the camera PCB is also smaller, making it 2.49mm narrower and 3.1mm shorter on the top.

There are tighter tolerances on the square section at the top of the case that frames the adapter ring clamp, resulting in less of an unsightly gap while still allowing assembly without removing the ring.

The bottom of the case has been extended to follow the lines of the adapter ring / tripod mount, this also hides the cable connector.

The vent slots that were on the rear of the case have been removed.

The orientation of the model has been corrected so the 'front' part doesn't require flipping prior to printing.

Note: You will have to connect the camera cable prior to assembly. Disassembly is required to disconnect the cable.