Wraith Kunai Heriloom Holder with LED-Lighting

Some assembly required.
You need a soldering iron, some thin wires, some hotglue and some small heat shrink to ilosate the soldered wiring.
First unsolder the USB-Plug from the LED-Strip i linked, or an identical one to this one if you can not order it like this from where you live. Then cut the LED-Strip to length. Then scratch off the coating from the solder pads on the led strips and solder your plus and minus wire to them. Then put the wires through the wirechannel i made and stick the strip in its place. Make sure to solder on the wires as flat as possible to get the refractor on the strip without it sticking up. The refractor should hold in their place without any glue or anything but feel free to apply some if you want to.
the stick the to LED Holders into the base, twist the plus wires and the minus wires together seperately, put some heatshrink over them, stick the USB Plug cable through the base and solder it together with the wires from the LED-Strips. Now test if everything works but make sure plus and minus dont touch each other when testing. if everything works pull the heatshrink down make it warm and glue everything in plane. Voila youre done.