Created for the H705 Govee Permanent Outdoor Lights (Non Pro Edition).
I'll clean up the Fusion file and publish those shortly.
General Instructions
- I'd recommend PETG at minimum for these prints (this is what I used)
- ASA would likely be great, but I didn't have any to test with
- All printed on a basic Ender 3v2 w/ a upgraded direct drive hot end (to do PETG)
- Screws used were 8x3/4 Metal Screws
Govee Clip.stl
- requires supports
- should be a snug fit, though I found sometimes some lights were tighter than others
- I recommend 8x3/4 screws (if your soffits are aluminium please use metal screws, ideally self tapping)
Govee Clip (Non countersunk).stl
- Identical to the above however the mounting screw holes are not countersunk
- If you print this inversed (top on bottom of plate) you should not need supports
Govee Cord Clip.stl
- Handy to secure cables around corners or to take up slack
Govee Peak Clip (Wedge).stl
- I used this to create a flat surface to mount the lights at the peaks of the dormers on my roof.
- First you screw this into the soffit/wood of your peak
- Then you screw the
Govee Clip.stl to this
- I did not pre-create the holes for the
Govee Clip leaving room for adjustment
- I suggest printing at a higher fill rate so there is more material for the
Govee Clip to screws to find purchase.
Govee Cover.stl
- If you have lights you don't want visible (say crossing from one peak to another or down to another level) and you don't want to disable the lights via Govee or WLED then you can simply cover them with this
- Designed to fit over the
Govee Clip.stl
Govee Installation Tool.stl
- Handy for consistent alignment and holding the clips and lights overhead while screwing them in.
mg3dp
