January 5, 2024
Description
Prey Neuromod
See the provided assembly instructions for details.
BOM
Printed
1x Neuromod - Antenna Front (I cut mine from thin steetmetal, may be hard to print)
1x Neuromod - Antenna Top (I cut mine from thin steetmetal, may be hard to print)
1x Neuromod - Body
1x Neuromod - Internal 1
1x Neuromod - Internal 2
1x Neuromod - Lens
2x Neuromod - Liquid Nut
1x Neuromod - Plunger
1x Neuromod - Trigger
2x Neuromod - Vial Connector
1x Neuromod - Vial (print clear/translucent)
2x Neuromod - Wire Nut
Non Printed
200mm - 3mm black wire/tube
200mm - copper wire (strip plastic sheathing off regular copper electrical wire)
2x M3 nuts
2 x M3x6mm countersunk screws
black heat shrink
2x M1x5mm screw
3x M1x3mm screw
1mm wire (to be wound into spring)
2x 25 Gauge needle
1x waterslide printable paper - clear (Some decals will have better contrast printed on white paper) https://www.amazon.com.au/Water-Slide-Transfer-Transparent-Printable-Tumblers/dp/B07WC89JWF
3x circuit boards (mine came from a dead hard drive)
various capacitors for aesthetics.
Electronics (optional)
1x 3mm red LED
1x 3mm green LED
1x 3mm blue LED
1x 3mm UV LED
4 x resistors to suit LEDs and power supply
1x lithium ion charging board and battery (or substitute for coin cell)
License:
Creative Commons - Attribution - Non-Commercial - Share Alike