AtomRC Flying Fish Top Hatch

This is my attempt at recreating the top hatch of an AtomRC Flying Fish. Definitely not a perfect replica, but much better than no hatch at all! If you're hatch is missing or damaged, give my 3d printed version a shot.
I used white PLA and printed the hatch vertically stood up on the wider end with supports and brim adhesion for the best results. Secure the hatch and the VTX antenna with some reinforced strapping tape at the front and back.
I've tested this hatch in flight and it performs just fine and keeps the VTX and flight controller at or under 103 degrees F.