A remix of Nation1991s remix of RockyMtnMarks Curved Modular Card Holder.
Changes in v2:
- Made the tray have the same curve as the card holder for symmetry
- Raised the walls to better prevent cards falling forward into the tray
- Optimized the tray walls making them 2.4 instead of 2.5 for better results
Updated 2024-04-05
Added new revision with more enhancements
Changes in v5
- Remodeled the tray instead of editing the existing one
- Lowered tray from 2.5mm to 1, matching the lowest card slot and reducing the total amount of filament needed
- Added chamfer to the close edge of the tray to make getting tokens out easier
- Reduced total width for consistency in modeling. Previously was swiped at 0.1255, reduced to 0.125 (also means 8 of them should slot together for a circle)
Phat32
