Travel Cover for Hot Air Brush R-06

My wife wanted a cover to protect the tines of her new Hot Air Brush (blow drier and hairbrush in one) for travel. It is supported by the narrower hole around the metal body of the brush with no pressure on the tines. I think it turned out pretty good. Who knows if anyone else in the 3D printing community will have use for this, but doesn't hurt to share :-)

Printed in PETG. Your latch performance may vary with other materials. PLA doesn't flex as much but try it out and let us know in the comments.

For the hinge pin, I tried switching to a .2mm nozzle, but still ended up cutting the slotted clip end off and just press-fitting the shaft. You could also use some wire, or a bbq skewer.