FlashForge Dreamer Short Fan Filament Guide Clip

#FlashForge Dreamer Short Fan Filament Guide Clip

These are used to clip the filament guide tubes onto the fans on the back of the Dreamer.

There are 2 clips: A and B. Both A and B are used on the right and left fan. Take a look at the photo to see the proper positioning for the clips on the fans.

My Dreamer is the older model with a foggy door that did NOT include fans on the back. I added 4 of my own 80x80x15mm fans on the back and sides (see http://www.thingiverse.com/thing:667612) of my Dreamer for added cooling. Once I did that, my original filament guide tube clips no longer fit on the back. So I had to create these new shorter filament guide tube clamps. They work well.

Note: I am powering my 4 custom added fans using the extra power terminals inside my FlashForge Dreamer's power supply. They are attached to a switch and thermostat I also added so that I can manually turn them on or have my thermostat turn them on automatically. The power supply my Dreamer came with supplies enough power to run 4 additional 80x80x15mm fans, 4 additional short 24 volt LED light strips, and a thermostat! Pretty sweet!

##See Also

FlashForge Dreamer Thermostat Mount found here: http://www.thingiverse.com/thing:682667

FlashForge Dreamer Side Panel Fan Mount found here:
http://www.thingiverse.com/thing:667612