Creality Nebula Camera Holder for Ender V3 KE

This is a small remix of Hapedevee's excellent original design. For my printer, the top portion of the mount (where the clip is) ran into the end of the X-Axis linear rail.

This remix just extended the top portion of the holder back 6.5mm toward the Z-Axis gantry and put the holding clip on the end. While I had the model open, I also increased the depth of the bottom clip to provide a bit more holding power.

NOTE: THIS WILL NOT WORK WITH THE X-AXIS G-SENSOR BRACKET INSTALLED!
Just pop the camera bracket off if you ever decide to re-run the vibration calibration.

I printed this with the cable routing "arm" down and with supports everywhere the slicer wanted them.

As with the original design, everything slips into place without needing to do ANYTHING to the printer.

Thanks again to Hapedevee for taking the time to create such an elegant camera holder.