A motor mount that combines air intake for better cooling and counterweight for the tail. Say goodbye to motor overheating!
---
### Features
- Integrated air intake for cooling ; no more motor overheating, even with stock 6S setup!
- Separate motor firewall design, for localized high-temperature material usage.
- Flushed out tail for lower noise level, due to less turbulent airflow over prop.
- Doubles as tail counterweight for 6S1P 5200mAh LiPo or 6S2P 10Ah 21700 setups.
- Designed around motors with 19x19mm M3 mounts; allows high-pitch props to be used.
---
### Tips
- This part assumes you are using 6S setup; 4S 20Ah setups maybe possible to use this, I believe?
- For battery weights around ~750g, target for 120g printed part weight; maximum attainable printed weight is estimated to be around 270g.
- These parts might serve as basis for 70mm EDF conversion kit later...?
---
### Required Parts
- 4x M3 60mm bolt (for motor mounting)
- 4x M3 30mm bolt (for fuselage mounting)
---
### Printing
- "Firewall": Vertical orientation, (any high-temperature material (A)), 3 wall, 100% infill
- "Body": Vertical orientation, PETG, 3 wall, 10% infill (adaptive cubic) (B)(A): I used PA6-GF for reference.
(B): This is for target printed weight of 120g combined. If using heavier battery, adjust infill or wall count accordingly for increased weight.
---
### Reference Configuration
- Flight Controller: AtomRC F405 Deluxe
- ESC: Hobbywing Platinum V4 60A
- Motor: Hobbywing XRotor 3115 1050KV
- Prop: Gemfan 8060
- Battery: 6S1P 5200mAh LiPo OR 6S2P Molicel P50B
- GPS: AtomRC Stock
- RC RX: RadioMaster RP4-TD
- VTX: DJI O4 Pro
svrline
