Large Realistic Roses

Boost MeBoost if you found this model to be valuable!

 

🚨 New model drop: Fold-n-Seal Bag Clips 🚨 

Pop quiz! What do people love almost as much as flowers? Perfectly sealed chip/food bags!

Get it 👉 https://makerworld.com/en/models/1614897 

 

 

This remix adds a stem + leaves with simple threaded assembly, no glue is needed. 

• Added a stem with leaves, not present in the original model
• Restored the original green part under the rose printed flat instead of with supports - it looks better this way and is easy to bend into shape after printing
• Increased the size to a more realistic size to take advantage of the 256mm bed (a1-mini you should go print the other model this is based on)

There are two stem plates you can choose from - with or without leaves. I like printing a mix if you are making a bouquet.

 

The supports on the stem are pretty easy to remove, you may want a deburring tool to remove any roughness but it shouldn't be too bad.

 

The leaves are thin enough you can carefully twist and bend them to the desired angle without heat, but a heat gun or even hair dryer will work. Lighter would also work but you need to be careful not to light it on fire and this is not recommended.

 

The sepals (green part under the rose) can also be hand-bend without heat, but again, a little heat makes it much easier to move them into place.