Expedition 33 Keychain .2 Nozzle

Know that this can only be printed with a .2 nozzle. If you want to print a similar keychain with a .4 nozzle, you can find it here: https://makerworld.com/en/models/1640406-expedition-33-keychain-4mm#profileId-1733218 

You could print this model with a .4 if you make it 100% bigger. But that is not recommended.

This print also has some assembly mid print. At about the halfway point you need to remove the back from the build plate and place it firmly into the empty space of the second part. As shown in the following pictures.

Be sure that it is placed face down and firmly pushed into place. It is OK if it is sticking out a little bit. Especially at the bottom. The Printer should push it in place as it prints over it. Once it is in place press play. You may want to watch it lay down the first layer, just in case it pops out.

Boost MeIf you like my work, please leave a boost!