Modular Holster Project (TPU)

Hey guys, 

I was not very happy with my current holster setup and wanted to make it more custom and adjustable to me so I have been developing and testing these models for the past couple of weeks and am very happy with how it has come out so I wanted to share! 

the Modular Holster System is designed so that it can be mounted, angled, or adjusted however you see fit. The main system is more so designed for loops, or belt clips to be mounted lower on the system, whereas the lite can be used with your mono-blocks, and standard clips without it getting in the way. The main system along with the Lite are 5mm Holes to accept hardware with a standard 18mm spacing. Both stystem hosts the ability to angle your holster up to 45 degrees without issues. 

The claw was made specifically for the WTP holsters that have a single mount position, but I know there are some other creators out there that have some great claws that may work if this one does not! 

The belt loops are nothing special, but offer great retention and fit a standard belt with no issues. (will likely be updating in future for other belts, performance enhancements)

I have been running and testing this set up for a little over two weeks now and have not had any issues, everything was printed in a generic TPU 95A with a Max Temp of 210 and Low of 200. Enjoy!