Aventon Aventure BC280 Screen Parts

When I got my used Aventure, the screen mounts were broken and the screen was loose in its housing.  I drew up new screen mounts that are a bit different design but work just the same, allowing lots of adjustment range.  You'll need a couple of M3x16 bolts and nuts.  If you print in PETG, PET, PA6 etc you should be able to flex it enough to get over the handlebars.  I'm not sure about PLA.  I glued my screen cover on because I wanted it to make the edges of the screen water resistant but it pops on and stays just fine without glue.  I printed in 95a glow TPU. 

Boost MeIf this helped you, please consider helping out with a boost!